8. INSPECTION AND MAINTENANCE BEFORE RIDING
13
ROUTINE INSPECTION
Check Items Check Key Points
Engine Oil Is there enough engine oil?
Fuel Is it enough? Is it Octane 90 or above
Front
Braking condition?
(Drum type brake lever free play: 10~20mm)
Brake
Rear
Braking condition?
(Drum type brake lever free play: 10~20mm)
Front
Is tire pressure normal?
(Standard: 1.75kg/cm
2
)
Tires
Rear
Is tire pressure normal?
(Standard: 2.0 kg/cm
2
for 1 person, 2.25 kg/cm
2
for 2 persons)
Steering Handle Does the handle vibrate abnormally or is difficult to turn?
Speedometer, lights, and
rearview mirror
Is it operated properly?
Do lights come on? Can it be seen clearly from behind?
Tightness of Main Components Are screws, nuts loosen?
Abnormal Points Do the previous troubles still exist?
CAUTION:
If any problem founded during routine inspection, correct the problem before using the scooter again,
have your scooter checked and repaired by the “SYM dealer or authorized service personnel” if
necessary.
FUEL INSPECTION
Turn ignition switch key to "
" position, and check fuel gauge's needle range to make sure there is
enough amount of fuel in the fuel tank.
This scooter’s engine is designed for using the unleaded fuel of octane 90 or above.
Firmly secure the main stand on the ground, shut off the engine and keep flames away from the
scooter when refueling.
Do not fill above fuel upper limit level when refueling.
Make sure the fuel tank cap had been tighten properly.