Synesso S200 User Manual

4
The conductors of the power supply cord are
marked “L1”, “L2” for the ungrounded (“hot”)
supply conductors and “G” for an equipment
grounding lead.
Warning: Risk of Fire. Use UL Listed Grounding
Type Plug rate for 220 Volts, ______ Amperes,
_______ Phase, #______ Wire. Plug to be Selected
and Installed only by Qualied Service Personnel.
Electrical
WARNING: Disconnect from
power supply before servicing
AVERTISSEMENT: Couper
l’alimentaon avant l’entreen
et le depannage.
California
only:
WARNING
This product can expose you to
chemicals including lead, which is known to
the State of California to cause cancer, birth
defects, or other reproducve harm. For
more informaon, go to
www.P65Warnings.ca.gov.
Electrical
Box:
This equipment is to be installed to
comply with the applicable federal,
state or local plumbing codes.
Under drain
tray
Materials informaon for Synesso™ machines:
• All stainless steel coming into contact with the water supply is 300 series
• All brass ngs are low lead per the CA360 specicaons or beer
• All electronic devices are lead free
• All gaskets are made from food-contact safe material
Test Informaon:
• Brew (coee) tanks are hydrostacally tested to 375 psi
• Steam tanks are pressure tested to 75 psi
• The electrical system is subject to an electrical withstand test of: 1.20 kV AC for 1 sec-
ond, with a 7 mA limit.
IMPORTANT Informaon for Synesso™ Espresso Machines: DISCONNECT FROM POWER BEFORE SERVICING.
• Read the enre manual before operang this machine.
• Steam and condensaon from the steam wand discharge are very hot and may cause burns.
• The steam wand ps and bases become hot during use: do not touch these surfaces.
• Cover the steam wand p or submerge in a lled pitcher to safely divert the steam before opening the
steam valve.
• Never remove the steam wand from the product that is being heated when the valve is open.
• Never remove the portalter from the machine during the acve brewing process.
• Keep water and moisture away from any electrical device or live power.
• Steam tank water is heated to 260°F (126°C) or more; Use cauon near steam tank.
• The brew groups deliver water as hot as 210°F (99°C). Avoid exposure to this water.
• The hot water mix valve can be adjusted to deliver water as hot as 212°F (100°C), which can cause severe
burns: please use cauon when acvang this water source.
Safety Label Locaons:
Synesso™ complies with UL regulaons by posng the following labels on its machines:
SAFETY WARNINGS

Synesso S200 Specifications

General

Brand	Synesso
Model	S200
Category	Coffee Maker
Language	English