TM9100 Mobiles: 110 W Mobile Installation Guide Preparing the Installation 11
© Tait Electronics Limited October 2005
3.4 Programming Settings
Make sure that the radio has been correctly programmed before installing it.
Note The radio can only be programmed via the control head
microphone socket, not via the sockets on the dual RJ-45 head.
In particular, programming must have:
■ Selected the B1 band.
■ Enabled the check box ‘Configure as 110 W mobile’. This modifies the
setting of a number of items, including the power output to the external
RF amplifier.
■ Configured the channels that the radio will operate on.
■ Configured the AUX_GPI3 line for ignition sense. To do this, program
it as an input, select the action ‘Power Sense (Ignition)’ and specify that
the active state is ‘High’. For more information, refer to the online help
of the application software.
■ Configured any inputs and outputs on the auxiliary connector that will
be used for external devices or signals
Important Incorrect programming settings can result in damage to the
external RF amplifier.
For details, see the programming software online Help.
To Next Page
Loading...
Need help?
General
