16
End of operation
After cleaning
Finishing work
Drain the recovery tank / fresh water tank
The disposal of the dirty water or the cleaning solution must be carried out in
accordance with the appropriate national regulations.
Proceed as follows for both tanks:
t Stop the flow of solution.
t Drive a further few metres to avoid subsequent ,,dripping’’.
Very important when using contact pads!
t Press the brush pressure button.
The tools will be stopped.
t Drive on a few metres further in order to pick up the remaining waste water.
t Only now switch off the vacuum unit.
The suction nozzle rises and the suction aggregate keeps on
running for approx. 10 sec.
t Pull out the key and operate the parking brake (see Parking brake‘ Page 9).
Always drain and clean the recovery tank every time you use the machine.
If the dirty water is allowed to stand, unpleasant smells and deposition of the
dirt will take place after a few hours.
t Pull out the key and operate the parking brake (see Parking brake‘ Page 9).
t Remove the hose from its holder.
Open the red cover at handle height and slowly lower the end of the hose
to pour out the contents.
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
To Next Page
Loading...
Need help?
General