23
I25 I24 I23 I22 I21 I20 I19 I18 I17 I16 I15 tr sv ro pt pl no nl it fr fi es en de cz
After completing the charging and with immediate use
Charging procedure for traction block batteries (machines with external
battery charging unit)
Charging procedure for wet batteries (machines with external battery
charging unit)
Maintenance of batteries (only wet batteries)
Please follow the instructions of use for your battery charger!
Opening battery compartment for maintenance
Closing battery compartment
After end of maintenance
• Unplug the connection to the mains socket.
• Check that the machine has been switched off with the keyswitch.
• Plug the external battery charging unit into the charging plug.
• Start the battery charging unit.
Caution:
Follow the instructions of use for your battery charger!
Caution:
If the machine is assembled with a wet battery kit (optional) the
machine must be used with wet batteries only!
Wet batteries must not be charged with the internal charger!
Battery compartment must be open during charging.
Wet batteries must be charged in ventilated rooms only!
The gas given off could be ignited!
• Switch the machine off using the keyswitch and remove the key.
• Check that the tanks are empty.
• Turn the unlocking device counter-clockwise
through 90°. Use the supplied sheet metal
spanner to do this.
Tank position for charging.
• Plug the external battery charging unit into the charging plug.
• Start the battery charging unit.
Caution:
Follow the instructions of use for your battery charger!
Caution:
When maintenance of batteries takes place, they must be
disconnected from the machine!
• Check that the machine has been switched off with the keyswitch.
• Lower the squeegee.
• Check that the tanks are empty.
• Turn the unlocking device counter-clockwise
through 90°. Use the supplied sheet metal
spanner to do this.
• Lift the tank until it locates into its self support
position.
Tank position before it is altered for battery
maintenance.
• Stand behind the machine.
• Carefully open the battery compartment until
the drive handle is lying on the floor.
Tank position for battery maintenance.
• Stand behind the machine and lift the tank until
it rests on the tank self support.
• Hold the tank firmly, and then turn the lock
through 90°.
Now lower the tank until it locates into place.
• Raise the squeegee.
To Next Page
Loading...
Need help?
General