EasyManuals Logo
Home>TCL>TV>55C815

TCL 55C815 User Manual

TCL 55C815
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
7
Chapter 2 Getting Started
Switching On
Follow the instructions on this page on how to switch on your TV set
and the remote control before going on to following pages describing
how to use the channel set-up procedure.
1.
Insert two AAA batteries in the remote control.
Precautions on using batteries:
- Only use the battery types specied.
- Make sure you use the correct polarity.
- Do not mix new and used batteries.
- Do not use rechargeable batteries.
- Do not expose batteries to excessive heat such as sunshine,
re or the like, throw them in a re, recharge them or try to open
them, as this could cause them to leak or explode.
- Remove the batteries from the remote control if you are not using
it for a long period of time.
- Attention should be drawn to the environmental aspects of battery
disposal.
2.
Connect the power cable FIRST to the television, THEN to a mains
socket. (
Note
:
If the power cable is connected to the television,
please only connect the power cable to the mains socket.
)
Your TV set should only be connected to an AC supply. It must not
be connected to a DC supply. If the plug is detached from the ca-
ble, do not, under any circumstances, connect it to a mains socket,
as there is a risk of electric shock.
Note
:
The gures are for representation only, the location of power
socket of the television may differ depending on the model.
3.
Connect an outside aerial to the ANTENNA IN socket at the back
of the TV set.
The aerial socket (75 OHM - VHF / UHF / cable) can be used for
connecting an external aerial or other equipment tted.
Note
:
If you want to receive the signal from your cable or cable
box, please connect a coaxial cable to the CABLE IN socket at the
back of the TV set.
4.
When powered on, the TV will be turned on directly or be in
standby mode.
If the power indicator lights up, the TV set is in standby mode.
Press the
button on the remote control or on the TV set to turn
on the TV.
Switching Off
To put the TV set into standby mode, press the button on the
remote control. The TV set remains powered up, but with low
energy consumption.
To switch off the TV set, unplug the mains socket from the mains
outlet.

Table of Contents

Other manuals for TCL 55C815

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TCL 55C815 and is the answer not in the manual?

TCL 55C815 Specifications

General IconGeneral
Screen shapeFlat
Response time10 ms
Display diagonal55 \
Display brightness470 cd/m²
Display technologyQLED
Native aspect ratio-
Native refresh rate50 Hz
Peak luminance ratio72 %
LED backlighting typeEdge-LED
Supported video modes2160p
Viewable size diagonal1390 mm
Display diagonal (metric)139.7 cm
Supported graphics resolutions3840 x 2160
Motion interpolation technologyPPI (Picture Perfomance Index) 2800
Dynamic contrast ratio marketing nameMega Contrast
RF connector typeF, IEC
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Audio Return Channel (ARC)Yes
Ethernet LAN (RJ-45) ports1
Consumer Electronics Control (CEC)T-link
Common interface Plus (CI+) version1.4
Tuner typeAnalog & digital
Analog signal format systemNTSC, PAL, SECAM
Digital signal format systemDVB-C, DVB-S2, DVB-T2
Video appsAmazon Prime Video, Netflix, YouTube
Smart modesGame, Movie, Sports
Lifestyle appsGoogle Apps
Operating system version9.0
Operating system installedAndroid
Number of OSD languages29
Firmware upgradeable viaNetwork, USB
On Screen Display (OSD) languagesALB, BUL, CRO, CZE, DAN, DEU, DUT, ENG, ESP, EST, FIN, FRE, GRE, HIN, ITA, LAT, LIT, MAC, NOR, POL, POR, RUM, RUS, SER, SLK, SLV, SWA, TUR, UKR
Audio decodersDTS, Dolby Atmos, Dolby Digital, DTS-HD, Dolby Digital AC4, Dolby TrueHD
RMS rated power35 W
Wi-Fi standards802.11b, 802.11g, Wi-Fi 4 (802.11n)
Bluetooth profilesA2DP, HID
AC input voltage220 - 240 V
Energy efficiency scaleA to G
Power consumption (max)180 W
Power consumption (standby)0.28 W
Power consumption (typical)112 W
Product colorBlack
Mercury content0 mg
Heavy metals freeHg (mercury)
Panel mounting interface400 x 200 mm
Processor cores4
Audio formats supportedMP3, WMA
Image formats supportedBMP, HEIF, JPG, PNG
Video formats supportedAVI, H.264, H.265, MKV, MP4, MPEG2, MPG, TS, VP9, WEBM, WMV
Picture processing technologyTCL IPQ 2.0 Engine
High Dynamic Range (HDR) technologyDolby Vision, High Dynamic Range 10 (HDR10), High Dynamic Range 10+ (HDR10 Plus), Hybrid Log-Gamma (HLG)
Remote control typeRC602S6+RC802N4
Package depth168 mm
Package width1400 mm
Package height875 mm
Package weight23800 g
Battery typeAAA
Battery technologyAlkaline
Truck type87 cbm
Pallet height1870 mm
Pallet length800 mm
Pallet weight255400 g
Pallet net weight15000 g
Quantity per truck280 pc(s)
Quantity per pallet10 pc(s)
Number of pallets per truck28 pc(s)
Maximum number of stacking cartons3 pc(s)
Weight and Dimensions IconWeight and Dimensions
Depth (with stand)295 mm
Height (with stand)783.4 mm
Weight (with stand)17800 g
Depth (without stand)64 mm
Width (without stand)1227.4 mm
Height (without stand)739.7 mm
Weight (without stand)17400 g

Related product manuals