9
Connections and Setup
Switching On
1. Connect the power cable FIRST to the television, THEN to a mains
socket. (
Note:
television.)
WARNING:Your TV set should only be connected to an AC supply.
The TV’s standby light should be turned on. It must not be connected
to a DC supply. If the plug is detached from the cable, do not, under
any circumstances, connect it to a mains socket, as there is a risk of
electric shock.
2. Connect an outside aerial to the ANTENNA IN socket at the back of
the TV set.
The aerial socket (75 OHM - UHF / cable) can be used for
3. When powered on, the TV will be turned on directly or be in standby
mode.
If the power indicator lights up, the TV set is in standby mode. Press
the
button on the remote control or on the TV set to turn on the TV.
Initial Setup
Welcome wizard appears, which guides you through the initial setup process.
remote, connecting to the network, and more. During each step, either make a choice or skip the step. If you skip a
step, you can perform the setup later from the Settings menu.
Notes:
- It’s recommended to select Set up Google TV setup process.
on the remote control, selecting
(Settings)
> Set up Google TV and pressing OK
-
When you pair your remote, keep the remote control and TV within 1 meter, and follow the on-screen guide for
will be prompted to pair the remote with the TV again when you use the Google
Note:
the location of power socket of the television
• To put the TV set into standby mode, press the button on the remote control. The TV set remains powered up,
but with low energy consumption.
•
outlet.
Note: In order to save energy and protect environment, certain models are designed with a relay switch. It is a normal
To Next Page
Loading...
Need help?
General
