3. Directions for Use
3.8 Auto Search (Setting TV Channels)
You can set your TV to receive local TV
channels (From an antenna) or Cable TV
channels(when you have Cable TV service).
Then, use AUTO SEARCH to set up
channels that are available for you. This
makes it easy for you to select only the
available TV stations when you press CH+ or
CH-. Before you start AUTO SEARCH,
connect the Antenna or Cable TV signal as
detailed on pages five-six; set TV/CATV as
described on page11.
Add/Erase
Fine 0
Favorite list
Add
2Channel
Manual Up
TVTV/Cable
Auto search
Add/Erase
Fine 0
Favorite list
Add
2Channel
Manual Up
TVTV/CATV
Press MENU to see the menu.
Press CH+ or CH- repeatedly to
highlight Auto search.
Press VOL+ or VOL- to highlight
(Preset).
Press CH- to enter Preset submenu.
Press VOL+ to start programming TV
channels. Press the VOL- if you need
to stop channel programming during
the process.
When channel setup is complete, the
TV will go to its lowest channel.
Programming
Please Wait
TV 2
Press CH+ or CH- to see
which channels are in the
TV s memory. You can still
select non-memorized
channels using the Number
buttons on the remote
control.
To delete unwanted
channels from the
You cannot select Preset
menu if the TV is set to
AV1/S- video, AV2, or YUV.
Press TV/AV repeatedly to
get to the TV channels.
TV s
memory or to add more
channels, see ADD/ERASE
on page14.
Helpful Hints
Auto search
Stop
Brightness
Contrast
Tint
Blue Back
Noise Red.
C. Temp
50
50
50
On
Off
Normal
Sharpness 50
Color
50
Colour Television Chassis: M123A
13
To Next Page
Loading...
Need help?
General
