To Next Page

To Previous Page

Colour Television Chassis: M123A

1. Remove the complete Side I/O assembly after

unscrewing the 2 fixation screws [1].

2. Release the two fixation clamps [2] and lift the

board out of the bracket

Figure 4-2

4. Mechanical Instruction

Index:

1. Rear Cover Removal

2. Service Position Main Panel

3. Side I/O Panel Removal

4. Rear Cover Mounting

Note:

Figures can deviate slightly from the actual situation, due to different set executions.

4.1 Rear Cover Removal

1. Remove all fixation screws of the rear cover.

2. Now pull the rear cover backward and remove it.

4.2 Service Position Main Panel

4.3 Side I/O Panel Removal

4.4 Rear Cover Mounting

Before you mount the rear cover, perform the following checks:

1. Check whether the mains cord is mounted correctly in its guiding brackets.

2. Replace the strain relief of the AC power cord into the cabinet.

3. Check whether all cables are replaced in their original position.

1. Remove the main panel, by

pushing the two center clips

outward <1>. At the same time

pull the panel away from the

CRT <2>.

2. Disconnect the degaussing coil

and load speaker connector.

3. Move the panel somewhat to

the right and flip it 90 degrees

<3>, with the components

towards the CRT.

TCL CTR2116 User Manual

Questions and Answers: