3. Directions for Use
3.1 Basic Cable TV Connection
DVD INPUT
YCbCr
IN2
OUT
VIDEOAUDIORL--
75OHM
ANTENNA
INPUT
DVD INPUT
YCbCr
IN2
OUT
VIDEOAUDIORL--
75OHM
ANTENNA
INPUT
75 OHM
ANTENNA
INPUT
75 OHM
ANTENNA
INPUT
Cable TV company
Cable TV company
Cable Box
The cable TV signal into your home
may be a single cable (75ohm) or may
include a cable Box. In either case, the
connection to the TV is easy.
If your Cable TV signal comes
directly via a 75ohm coaxial cable,
use the following steps:
Connect the Cable TV signal to
the 75 OHM ANTENNA INPUT jack
on the rear of the TV. Screw it
Plug the TV s power cord into a
power outlet and turn on the TV.
Set TV/CATV to CATV as detailed in
page11.
Refer to AUTO SEARCH to set up
your available channels. Details
are on page 12.
If you have a Cable Box, use the
following steps.
Connect the Cable TV signal to
the IN jack on the Cable Box.
Connect the separate coaxial
cable to the OUT jack on the Cable
Box and to the 75 OHM ANTENNA
INPUT jack on the rear of the TV.
Plug the TV s power cord into a
power outlet and turn on the TV.
Set TV/CATV to CATV as detailed in
page11.
Set the TV to channel 3 or 4 (the
same as the Channel3/4 switch on
your Cable Box if applicable).
Change channels at the Cable
An RF coaxial cable (to
connect the Cable Box to
the TV) may be supplied
by the Cable TV company.
It is not supplied with the
TV.
You can connect a
Satellite Receiver the
Helpful Hints
Your Cable Box may have separate Audio and Video Out
jacks instead. If so, use audio and video cables to connect
the AUDIO/VIDEO OUT jacks of the Cable Box to the
Press the TV/AV on the remote control to set the TV to the
AUDIO/VIDEO IN 2 jacks on the rear of the TV.
Colour Television Chassis: M123A
6
To Next Page
Loading...
Need help?
General
