Technics SA-GX130D User Manual

AM (MW/LW) antenna connections
( AM loop antenna (included) )
Connect the AM loop antenna to the AM loop antenna terminals,
and mount it vertically to a column, a wall or rack.
• If this antenna is not properly installed, MW/LW broadcasts will
not be received.
• Be sure to connect the AM loop antenna even when an outdoor
antenna is used.
Pay attention to the following points when mounting the
antenna.
• Do not mount it horizontally (Doing so will impair reception).
• Do not mount it close to power cords, speaker wires or metal
surfaces (Doing so will result in noise).
• Do not mount it close to a tape deck. When the tape deck is be¬
ing used, chirping or beeping sounds may result.
When mounting the antenna to a column, a wall
or rack
Mount it vertically.
Move the antenna toward the right or left to find the point of best
reception.
When mounting the antenna to the unit
This type of installation may cause impaired reception or result in
signal noise. If possible, mount the antenna to a column, a wall or
rack.
Move the antenna toward the right or left to find the point of best
reception.
( AM outdoor antenna (not included) )
An outdoor antenna may be required in a mountainous region, or
if this unit is located inside a reinforced-concrete building, etc.
Use 5-12 m of vinyl-covered wire horizontally at the window, or
convenient location.
Note:
When the unit is not in use, disconnect the outdoor antenna to
prevent possible damage that may be caused by lightning. Never
use an outdoor antenna during an electrical storm.
7

Technics SA-GX130D Specifications

General

Brand	Technics
Model	SA-GX130D
Category	Stereo Receiver
Language	English