Technics SA-GX170 Operating Instructions

Direct access tuning
Specify the frequency using the numeric buttons to directly tune
to the desired broadcast station.
2] “BAND Press BAND to select “FM”, “MW” or
ALLOCATION “LW? I
The MW frequency step is set to 9 KHz before ship-
ment. To change to 10 kHz step, see below. The indicator changes each time the button is
pressed.
DIRECT TUNING Press DIRECT TUNING.
While cursor display is a om WV MHz
flashing (approx. 10
seconds)
(1
f2[3[\Yelo]
Press
the
appropriate
numeric
but-
If
the
desired
FM
frequency
is
107.90
tons to enter the frequency. MHz
lf the frequency has been input correctly, the fre-
quency display will blink.
1] — [0] > [7] — [9] > [9]
QUARTZ
: ; ; Loci (reir cary
1. If no button is pressed while the cursor display col nw fit toed
is flashing, the display wiil return to the frequen- = Ss
cy which is currently being received. To re- liluminates when tuned
specify the frequency, repeat the procedure
from step 3.
2. If the frequency has not been input correctly,
an error message will be displayed. In this
case, re-enter the frequency.
When the FM stereo broadcast is received: If noise is excessive in the FM stereo mode
This unit will automatically switch to FM stereo reception and the Press FM MODE. (The FM stereo indicator will switch off.)
FM stereo indicator will illuminate. The broadcast will be monaural, but noise will be reduced. If the
Sika button is pressed once more, stereo mode will be resumed.
LOCK STEREO in on
FM
i
LI
;
a
Li
re
To
change
the
MW
frequency
step
Press and hold BAND for about 3 seconds.
IHuminates (The frequency step changes to 10 kHz per step.)
To return to the previous step, press and hold BAND for about 3
seconds again.

Technics SA-GX170 Specifications

General

Brand	Technics
Model	SA-GX170
Category	Stereo Receiver
Language	English