Technics SC-CH730 User Manual

Playback
NORMAL POSITION/TYPE I
Metal/TYPE IV
The unit automatically identifies the type of tape.
This page shows an example using deck 1.
Press 4 OPEN/CLOSE on
deck 1, and then insert the
tape.
Load a tape with the exposed side facing
the cassette holder’s insertion part.
Insert the tape following the illustration.
The illustration shows an example when
you start playback from the beginning of
the tape side A (front side) with the “>”
playback button. Insert the cassette tape
until it touches the back of the com-
partment.
Press 4 OPEN/CLOSE on
deck 1 to close the cassette
holder.
| Press DOLBY NR to select ON
DOLBY NR or OFF. "O08"
Q “O08” appears
when the Dolby NR
system is on.
5 Press REV MODE to select the
reverse mode.
Each time you press REV MODE, one of
@® the indicators will appears.
pad : The deck plays one side only,
and then stops automatically.
32> =: The deck plays both sides, and
then stops automatically.
: The deck plays both sides
8 times, and then stops auto-
matically.
When you load tapes into both
decks; sequential playback will
be made. (See page 23.)
c=)
"HIGH SPEED FF/REW"
ch aaa
aaa Sei
iia
ist
6 Press Jor.
>: The forward side will play.
<1]: The reverse side will play.
7 CS) Adjust the volume level as you
like.
pown “up
To stop tape playback:
Press Q.
To change the deck to be used:
Press DECK 1/2 to select the deck you want to play.
Deck 1 or deck 2 indicator lights up.
About the <J and D> indicators:
While halted, fast forwarding, or rewinding:
Lights up orange.
While playing, recording or finding the beginning of a program:
Lights up green.
Do not insert your finger etc. into the cassette holder.
To reset the tape counter:
It is convenient to reset the counter when you want to memorize a
certain point (For example, when you want to rewind the tape to the
midway of the tune. etc.).
The tape counter indicates the amount of tape travel as a numerical
value based on the number of revolutions of the tape hub.
1. Press DECK 1/2 to select the deck to be used.
2. Press RESET.
@When the tuner or CD mode display shows, the tape counter
display will appear for about 1 second.
For your reference:
When the tape is travelling in the reverse direction, the value dis-
played on the tape counter will count down.
After “O00_” is reached, the display will switch to “999_” and then
continue counting down.
To change to the counter display mode:
While recording from CD or radio broadcast, you can check the tape
counter by switching the display mode.
While the display shows the CD or tuner mode display,
Press DISPLAY.
The display changes to the tape counter mode.
To return to the previous display, press DISPLAY again (or when
5 seconds have passed. the previous display will be resumed.)

Technics SC-CH730 Specifications

General

Brand	Technics
Model	SC-CH730
Category	Stereo System
Language	English