Technics SC-CH730 User Manual

1
FM
twuw
=
Press
FM
or
LW/MW
on
the
> a tuner/sound processor.
Press TUNING/TIMER v or a
on the tuner/sound processor
to tune in the desired station.
You can also select the station with man-
ual tuner operation.
3 sorenciose Press 4 OPEN/CLOSE on
deck 2, and then insert the
tape.
Insert the tape following the illustration.
The illustration shows an example when
(sess i you start recording from the beginning of
i the tape side A (front side) with the “>”
; S playback button. Insert the cassette tape
t
until it touches the back of the com-
a
partment.
4 ctendnee Press 4 OPEN/CLOSE on
7 deck 2 to close the holder.
45 Press DOLBY NR to select ON
DOLBY NR or OFF.
“OO B” lights up when the Dolby NR sys-
@Q tem is on.
Your attention is drawn to the fact that recording pre-recorded
tapes or discs or other published or broadcast material may
infringe copyright laws.
6 Press REV MODE to select the
REV MODE
reverse mode.
= One side will record, and then
the tape will stop automatically at
the tape end.
==> =: Both sides will record (forward
side—reverse side), and then
the tape will stop automatically
at the tape end.
cat> : Same as above. (When you
press REC PAUSE, “cx==>” will
be automatically switched over
to “==>” and returns when the
recording has been over.)
Press REC PAUSE to put the
cassette deck into the record-
ing standby mode.
REC PAUSE indicator will light.
“<1” or “>” indicator on the playback but-
tons flashes.
§ Press <J or P to start record-
ing.
To stop recording:
Press 01.
To cut an unnecessary part while recording:
1. Press REC PAUSE.
The cassette deck wiil go into the recording standby state.
2. To resume recording, press <1 or > corresponding to the direc-
tion in which recording is taking place.

Technics SC-CH730 Specifications

General

Brand	Technics
Model	SC-CH730
Category	Stereo System
Language	English