Before requesting service for this unit, check the chart below for
a possible cause of the problem you are experiencing. Some sim-
ple checks or a minor adjustment on your part may eliminate the
problem and restore proper operation.
If you are in doubt about some of the check points, or if the
remedies indicated in the chart do not solve the problem, refer to
the directory of authorized service centers (enclosed with this
unit) to locate a convenient service center, or consult your
Technics dealer for instructions.
(In U.S.A. consult MSC Authorized Servicenters for detailed in-
structions.)
I Problem Probable cause(s) Suggested remedy i
Changer will not play. A disc(s) or other foreign object(s) has fallen • Open the loading drawer, and then remove the
inside the changer, object.
Moisture has collected in the changer. • Switch on and allow the changer to dry out for about
one hour before using it.
The disc In the changer • Make sure the label is facing upward.
does not play. • Wipe the disc with a soft cloth.
• Replace the disc with a new one.
Play stops before changing
to the next disc.
A certain music passage
can't be played correctly.
These is noise from the
tuner or disturbance on the
TV screen.
When program play Is
started, an error message
(-E) appears on the
display.
An error message (-E)
appears on the display, and
the changer stops
operstlng.
The loading drawer stops In
the middle of opening.
The disc is upside down.
The disc is dirty.
The disc is scratched.
The disc is warped.
The disc is not within specified standards.
The loading drawer is open.
• Press the OPEN/CLOSE button to close the loading
drawer.
The disc is dirty. • Wipe the disc with a soft cloth.
The disc is scratched. • Replace the disc with a new one.
Caused by high-frequency signals from this • Use the changer further away from the tuner or TV.
changer. • If the tuner or TV's antenna is the indoor type, use an
outdoor one.
Play was started without a track being • Program a track.
programmed.
The mechanismof the changer hasbeen
improperlyadjusted.
• Turnthe unitoff andthen back on again.
However, if the loadingdrawer isfully open,take out
the compactdisc(s)at the front positionandthenturn
the unitoff and thenback onagain.
Product servT"ee
Do not attempt to remove the cover(s) or repair the unit
yourself.
Refer servicingto qualified personnelonly.
Product in£ormation
Forproductservice,productinformationor assistanceinpro-
ductoperation, refer to the servicenterdirectory.
/9
To Next Page
Loading...
Need help?
General
