5
these are not displayed after 60 seconds, remove the batteries and wait for at least
10 seconds before reinserting them.
3. After inserting the batteries into the sensor, the Weather Station will start receiving
data from the sensor. The outdoor temperature and the signal reception icon should
then be displayed on the Weather Station. If this does not happen after 5 minutes, the
batteries will need to be removed from both units and reset from step 1.
4. In order to ensure sufficient 868 MHz transmission there should be no more than 330
feet (100 meters) between the final position of the Weather Station and the sensor
(see notes on “Mounting” and “868 MHz Reception”).
5. Once the remote temperature has been received and displayed on the Weather
station, the DCF time (radio controlled time) code reception is automatically started.
This takes typically between 3-5 minutes in good conditions.
Note:
• The Weather Station will receive one outdoor sensor only.
• If after 10 minutes, the Atomic time (DCF time) signal has not been received, press the
SET key to manually enter a time initially.
• Daily DCF reception is done at 02:00 and 03:00 every day. If the reception at 03:00 is
not successful, then at 04:00 and 05:00 and 06:00 there are other tries, until one is
successful. If the reception at 06:00 is still not successful, then the next try takes place
at 02:00 next day.If reception is successful, the received time will override the manually
To Next Page
Loading...
Need help?
General
