Temperature alert on/off
Press and hold the key “-“ to set the temperature alert on or off.
• Alert on: Temperature alert symbol shown in display
• Alert off: Temperature alert symbol is not displayed
Information
• A temperature alert can be set-up for each channel.
• The set-up process cannot be completed if the maximum temperature selected is lower than
the minimum selected temperature.
• The minimum temperature selected must at least be 1°C below the maximum selected
temperature.
• An alarm sounds and the temperature display flashes, when the temperature from the signal
of the transmitter exceeds the set limits.
Sunrise /Sunset and Moonrise /Moonset
A nearby city of your location must be set to correctly display the time of your area.
• 150 cities are selectable for Sunrise /Sunset and Moonrise /Moonset times, a list of cities can
be found in the end of the manual
5 Weather forecast symbols
Sunny Slightly cloudy Cloudy Rainy Storm
Remarks：The weather forecast is determined by temperature, humidity and air
pressure. The forecast symbol may not match with the current weather.
Barometer and bar and data of history for the past 12 hour of air pressure
• Air pressure history can be displayed in hPa and inHg , for the past 12 hours, press the history
button repeatedly to change between -1,-2,-3…
• The bar graph indicates the air pressure history trend over the last 12 hours in 6 intervals: 0h, -
1h, -2h, -3h, -6h, and -12h. The “0h” represents the current full hour air pressure recording. The
columns represent the “hPa” (0, ±2, ±4, ±6) or inHg (0, ±0,06, ±0,12, ±0,18)
at specific time. The
“0” in the middle of this scale is equal to the current pressure and each change (±2, ±4, ±6 or
±0,06, ±0,12, ±0,18) represents how high or low in “hPa“ or “inHg” the past pressure was
compared to the current pressure.
~24~
• For accurate barometric pressure trends, the weather station should operate at the same altitude
for recordings (i.e. it should not be moved from the ground to the second floor of the house).
When the unit is moved to a new location, discard readings for the next 12 hours and correct the
height adjustment (see "Start-up") if needed.
Backlight
Press the key “SNOOZE/LIGHT“ to activate the display illumination for 5 seconds.
To Next Page
Loading...
Need help?
General
