WS9132 Manual
After receiver has created a connection to the outdoor remote
sensor, After 3 minutes it will enter the Radio control time receive
mode.
Reception of the DCF signal:
The clock will automatically search the DCF (radio controlled time)
signal after 3 minutes of any restart or changing of new fresh
batteries. The radio mast icon starts to flash.
At 1:00 /2:00 / 3:00 am, the clock automatically carries out the
synchronization procedure with the DCF signal to correct any
deviations to the exact time. If the synchronization attempt is
unsuccessful (the radio mast icon disappears from the display), the
system will automatically attempt another synchronization at the
next full one hour. This procedure is repeated automatically up to
total 5 times.
To start manual DCF signal reception, press and hold the “ ”
button for 3 seconds. If no signals received within 7 minutes, then the
DCF signal search stops (the radio mast icon disappears) and start
again at the next full one hour.
During RC reception，to stop searching radio signal, press the “ ”
button once.
Please note:
A flashing radio mast icon indicates that the DCF signal reception
has started
A continuously displayed radio mast icon indicates that the DCF
signal was received successfully
We recommend a minimum distance of 2.5 meters to all sources of
To Next Page
Loading...
Need help?
General
