Tecsun R-108 User Manual

www.tecsunradios.com.au
17
► SQUELCH FUNCTION
1. Press the [POWER] button to turn on the radio and select your
desired band by pressing [BAND] button；
2. Press & hold the [SQUELCH] button until "B" sound heard to switch
to the signal strength selection page with a symbol“ ”in display；
3. Rotate the [TUNING] knob to select signal strength“OFF-1-2-3-4-
5-6-7-8-9”；
4. Press the [SQUELCH] button again to confirm.
Note: If the [SQUELCH] button is not pressed shortly within 3
seconds, the radio will automatically confirm the adjustment; OFF
means turn off the squelch function; the higher the number, the
higher the signal strength needed to turn the sound on.
►TUNING SPEED SETTING
1. Turn on the radio and select any band you desired；
2. Press the [SQUELCH] button until you hear a sound of “B” and
release your hand. The corresponding reference table of“ ” “
” “ ” is shown below.

Tecsun R-108 Specifications

General

AM Frequency Range	520 - 1710 kHz
Tuning Steps (FM)	0.1 MHz
Tuning Steps (AM)	9 kHz / 10 kHz
Sensitivity (AM)	1 mV/m
Weight	150 g (without batteries)
Type	Portable
Modes	AM, FM, SW
Sensitivity (FM)	3 μV
Speaker	Built-in
Power Supply	2 x AA batteries or DC 3V