www.tecsunradios.com.au
►IMPORTANT NOTICE ABOUT USING
BATTERY
1.
If no battery has been installed for a long time, the clock of the
radio will stop to work. However, pre-stored frequencies are
still kept. The clock will work again after new batteries are re-
installed.
2.
When the battery power is low, the“ ” symbol flashes on
the display meaning that you have to charge battery.
3.
In case of the radio will not be used for a long period, take out the
battery to prevent liquid leakage which can damage the radio.
►RESET
If the radio does not function properly, you can perform a reset by
inserting a pin such as straightened paper clip, into the “RESET”
hole in the bottom of the unit.
►RADIO MAINTENANCE
1. Avoid violent shock, fall into the water.
2.
Do not place in direct sunlight, high temperature, humidity, and do
not use or keep the radio in an environment with temperatures
below 5℃, higher than +50℃, to avoid damage the LCD screen.
3.
Avoid wiping the radio surface by a liquid with corrosive chemical
composition.
4.
Do not disassemble your own radio to adjust internal component
parameters.
To Next Page
Loading...
Need help?
General
