Teka HLB 840 - Pyrolytic Program Activation Failure; Pyrolytic Program Not Heating; Door Locked After Pyrolysis Cycle; Door Locked After Cooling

40
Installation & Maintenance
• Deactivatethe doorlock followingthein-
structionsintheUser’sguidesuppliedwith
this manual.
• Tocontinuecooking,re-selectthedesired
cooking function.
I have turned the control dial to position
and selected a pyrolysis programme
(P1, P2 or P3) but the symbolashes
quicklyandabuzzersounds
• The oven door is not closed properly, so
the door cannot be locked and the pyrolyt-
ic process has been blocked.
• Checkthedoorandmakesureitisprop-
erly closed. Then set the control dial to the
requiredpositionandrepeatthesequence
to activate the pyrolysis.
I have turned the control dial to position
and selected a pyrolysis programme
(P1, P2 or P3) but the symbol does
not light up and the oven does not heat
up
• The door switch is not working even
though the door is properly closed.
• CalltheTechnicalAssistanceServiceDe-
partment as there is a fault in the door
switch.
The pyrolysis programme has ended and
the oven is cold, but the door is locked
and symbol and0:00areashing
• Youdidnotturnthecontroldialtoposition
when the pyrolysis programme ended.
• Setthecontroldialtoposition .
The control dial is in position and the
door is still locked
• Theovenhasnotcooleddowntothesafe
temperature limit.
• Waituntil theovencoolsand the symbol
goes off.
Technical specifications
WARNING
Iftheseproblemspersistdespitethesetips,
contact the Technical Service Department.
InformtheTechnicalServiceDepartmentofthe
kind of problem you are experiencing and give
the:
1. SerialNumber(S-No)
2. ModelofAppliance(Mod.)
This information is on the oven identication
plate which is on one side of the opened door.