Tektronix 2205 Operator's Manual

Applications
1. Set the left and right TRIGGER SOURCE controls to EXT and
EXT=Z, respectively.
2. Apply a signal to either the CH1 or the CH2 connector and
set the VERTICAL MODE selector to display the channel
used.
3. Apply the Z-modulation signal to the connector labeled EXT
INPUT or Z.
When the Z-modulation and the vertical-input signals are syn¬
chronized, Z-modulation is seen as gaps in the trace at the
modulation frequency. The size of the gap depends upon the
mark-to-space ratio of the Z-moduiation signal. The positive¬
going portion of the Z-modulation signal decreases display
brightness.
2205 Operator's
3-19

Tektronix 2205 Specifications

General

Brand	Tektronix
Model	2205
Category	Test Equipment
Language	English