DMM912/914/9161–32
Special Feature Descriptions
Auto power off
The auto power off automatically turns the meter off if no
controls or settings are changed within a set amount of
time. Turning the dial or pressing the gold or blue buttons
restores power. The meter returns to the default condition
of the dial position.
Use the Setup menu to adjust the auto power off delay.
You can disable the auto power off by pressing the blue
button when turning the dial from its off position.
Hold
Hold freezes the display to allow removal of the probes
from the test points without losing the reading.
Minimum and maximum values are still acquired while in
hold mode.
Auto hold
Auto hold operates like Hold except that the display
freezes whenever the reading stabilizes. The meter beeps
to indicate hold has been activated.
Auto fuse detection
The meter checks the integrity of the internal fuses
whenever they are needed for correct operation. If an
open fuse is detected, FUSE 1 or FUSE 2 is displayed
and two beeps sound.
To Next Page
Loading...
Need help?
General
