Tektronix DPO2012 Technical Reference

Specifications
Table 7: Power s
ource specifications
Characteristic Description
Source voltage 100 V
RMS
to 240 V
RMS
±10%, installation category II
Source frequency (90 V to 264 V) 44 Hz to 65 Hz
(100 V to 132 V) 360 Hz to 440 Hz
Power Consumption
<80 W at 85 to 275 V
AC
input
Table8:Datastoragespecifications
Characteristic Description
Nonvolatile memory retention time,
typical
No time limit for front-panel settings, saved waveforms, setups, and calibration constants
Real-time clock A programmable clock providing time in years, months, days, hours, minutes, and seconds
Table 9: Environmental specifications
Charact
eristic
Descrip
tion
Temperature
Operat
ing:
0°Cto+50°C(+32°Fto+122°F),with 5 °C/minute maximum gradient,
non-condensing, up to 3000 m altitude. Instrument will be in specification after a 10
minute
settling time and performance of SPC
Nonoperating:
-40 °C to +71 °C (-40 °F to +160 °F), with 5 °C/minute maximum gradient. Instrument
will b
einspecification after 5 minutes powered for each 5 ° C change settling time
and performance of SPC
Humi
dity
Operating:
High: 5% to 60% relative humidity, 30 °C to 50 °C (86 °F to 122 °F)
Low:
5% to 95% relative humidity, 0 °C to 30 °C (32 °F to 86 °F)
Nonoperating:
High: 5% to 60% relative humidity, 30 °C to 55 °C (86 °F to 131 °F)
Low
: 5% to 95% relative humidity, 0 °C to 30 °C (32 °F to 86 °F)
Altitude
Ope
rating: 3,000 m (9,843 ft)
Nonoperating: 12,000 m (39,370 ft)
Altitude is limited by possible damage to LCD at higher altitudes, independent of operation
Pollution Degree Pollution Degree 2, indoor use only
8 DPO2000 and MSO2000 Series Specifications and Performance Verification

Tektronix DPO2012 Specifications

General

Brand	Tektronix
Model	DPO2012
Category	Test Equipment
Language	English