Tektronix DPO2014 Programmer's Manual

Commands Listed in Alphabetical Order
*CLS can s uppre
ss a Service Request that is to be generated by an * OPC. This
will happen if a single sequence acquisition operation is still being p rocessed
when the *CLS command is executed.
Group
Status and Error
Syntax
*CLS
Related Commands
DESE, *ESE, *ESR?, EVENT?, EVMsg?, *SRE, *STB?
Examples
*CLS clears the oscilloscope status data structures.
CURSor?
Returns all of the current cursor settings.
Group
Cursor
Syntax
CURSor?
Examples
CURSOR? might return the following as the current cursor settings:
:CURSOR:FUNCTION SCREEN;HBARS:POSIT ION1 0.0000;POSITION2
0.0000;UNITS BASE;:CURSOR:MODE INDEPENDENT;VBARS:POSITION1
-19.0006E-6;POSITION2 -18.9994E-6;U NITS SECONDS
CURSor:FUNCtion
Sets or returns the cursor type. Cursors are attached to the selected waveform in
Waveform mode and are attached to the display a rea in Screen mode.
Group
Cursor
Syntax
CURSor:FUNCtion {OFF|SCREEN|WAVEfor m|VBArs|HBArs}
CURSor:FUNCtion?
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-111

Tektronix DPO2014 Specifications

General

Brand	Tektronix
Model	DPO2014
Category	Test Equipment
Language	English