Commands Listed in Alphabetical Order
Syntax
CH<x>:SCAle <N
R3>
CH<x>:SCAle?
Related Commands
CH<x>:OFFSet, CH<x>:POSition, REF<x>:VERTical:SCAle,
MATH[1]:VERTical:SCAle
Arguments
<NR3> is the vertical channel scale in units-per-division. The value entered here
is truncated to three significant digits.
Examples
CH4:SCALE 100E-03 sets the channel 4 scale to 100 mV per division.
CH2:SCALE? might return : CH2:SCALE 1.0000 indicating th
at the current scale
setting of c hannel 2 is 1 V per division.
CH<x>:TERmination
Sets the connected-disconnected status of a 50 Ω resistor, which may be connected
between the specified channel's coupled input and o scilloscope ground. The
channel is specified by <x>. There is also a correspond
ing query that requests the
termination parameter and translates this enumeration into one of the two float
values. This command is maintained for compatibility.
Group
Vertical
Syntax
CH<x>:TERmination
CH<x>:TERmination?
CH<x>:VOLts
Sets or returns the vertical sensitivity for channel <x>, where x is the channel
number.
Group
Vertical
Syntax
CH<x>:VOLts <NR3>
CH<x>:VOLts?
Arguments
<NR3> is the vertical sensitivity, in volts.
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-109
To Next Page
Loading...
Need help?
General
