Run application
software
Run applicati
on software
Each application is available for ten free trials on your instrument. These applications provide application-specific
measurement solutions. Some examples are described below. Additional packages may be available. Some applications
may not be available on your instrument. Contact your Tektronix representative or visit our Web site at www.tektronix.com
for more information.
Use DDRA Memory Bus Analysis to automatically identify DDR1, LP-DDR1, LP-DDR2, LP-DDR3, DDR2, DDR3,
DDR4, DDR3L, GDDR3 and GDDR5 read and writes.
Use DJA DPOJET Jitter and Eye Diagram Analysis , Advanced to reliably measure complex clock, digital, and serial data
signals. DPOJET Essentials included standard with all models.
Use D-PHY for MIPI D-PHY Transmitter debug, characterization and compliance testing (requires option DJA).
Use DP12 Display Port Compliance Software to validate your
IC, motherboard, and graphics card designs.
Use DVI Compliance Test Solution Software for DVI physical layer compliance testing.
Use ERRDT Frame and Bit Error Rate Detector to detect errors in high speed serial standards (requires option ST6G).
Use ET3 to perform 10/100/1000 Base-T Ethernet compliance testing.
Use HT 3 HDMI Compliance Test Software for HDMI compliance testing for ≥4 GHz models.
Use HT3DS HDMI Direct Synthesis for HDMI 1 .4 (requires HT3) for HDMI analysis.
Use LT Waveform Limit Testing to compare an acquired waveform to tolerance boundaries that you set.
Use MOST Essentials for electrical compliance and debug testing for MOST50 and MOST150.
Use MTH Communication Mask Testing Software for mask compliance testing on ≥4 GHz models.
Use MTM Communication Mask Testing Software for mask compliance testing on <4 GHz models.
Use PCE3 PCI-Express compliance test for Gen3. Used with DPOJET.
Use PCE compliance test for Gen1 and Gen2. Used with DPOJET.
Use PWR Power Measurement S oftware to quickly measure and analyze power dissipation in power supply switching
devices and magnetic components.
Use SDLA64 Serial Data Link Analysis Visualizer to emulate the serial data channel, de-embed a fixture, and add or
remove transmitter equalization.
Use SR-810B to enable s erial triggering and analysis of 8B/10B signals.
Use SR-AERO for MIL-STD-1553 Serial Triggering and Analysis.
Use SR-AUTO for Serial Triggering, debugging, decode and Analysis of C AN, LIN, and FlexRay signals.
Use SR-COMP to enable serial triggering and analysis of RS-232/422/485/UART signals.
Use SR-DPHY for MIPI-DSI1 and MIPI-CSI2 serial analysis.
Use SR-EMBD to enable serial triggering and analysis of I
2
C and SPI signals.
Use SR-ENET for serial analysis of Ethernet signals.
Use SR-PCIE Serial Data Compliance and Analysis (requires ST6G for serial triggering).
Use SR-USB to enable serial triggering and analysis of USB2.0 and USB3.0 signals.
166 MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO 5000B Series U ser M anual
To Next Page
Loading...
Need help?
General
