EasyManuals Logo
Home>Tektronix>Test Equipment>MDO32

Tektronix MDO32 Declassification And Security Instructions

Tektronix MDO32
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
Preface
This document helps customers with data security concerns to sanitize or remove
memory devices from the Tektronix 3 Series MDO Mixed Domain
Oscilloscopes.
These products have data storage (memory) devices and data output devices.
These instructions tell how to clear or sanitize the memory devices and disable
the data output devices. The instructions also tell how to declassify an instrument
that is not functioning.
Instrument code and calibration settings reside in nonvolatile flash memory.
Instrument setups and reference waveforms may also be stored in flash memory
or on USB drives connected to the instrument.
If you have any questions, contact the Tektronix Technical Support Center at
www.tektronix.com/support.
Reference
The procedures in this document are written to meet the requirements specified
in:
NISPOM, DoD 5220.22–M, Chapter 8
SFO Process Manual for Certification & Accreditation of Classified Systems
under NISPOM
Products
The following Tektronix products are covered by this document:
MDO32
MDO34
Required documents
To perform the procedures in this document, you might need access to the
3 Series MDO manuals listed below. These manuals are available on the
Tektronix Web site at www.tektronix.com/downloads.
3 Series MDO Service Manual (Tektronix part number, 077-1500-xx)
3 Series MDO Technical Reference Manual (Tektronix part number,
077-1499-xx)

Other manuals for Tektronix MDO32

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tektronix MDO32 and is the answer not in the manual?

Tektronix MDO32 Specifications

General IconGeneral
BrandTektronix
ModelMDO32
CategoryTest Equipment
LanguageEnglish

Related product manuals