Clear and Sanitize Procedures
Sanitizing an
Application Module
To sanitize an application module, follow this procedure to return the module to
the default state.
NOTE. This p
rocedure is for an application module that has its license transferred
to an oscilloscope. If the module license is not installed in an oscilloscope, the
module is already in the default state.
1. With the application module installed in an oscilloscope that contains the
module’s license, push the front-panel oscilloscope Utility button.
2. Use the Multipurpose a knob to select Confi g.
3. Select A
pplication Module Licenses.
4. Under the Transfer Licenses menu, select to transfer the license to the desired
applic
ation module. For e xample, to sanitize the DPO4AERO module, select:
Tr ansfer DPO4AERO License to Module.
NOTE. If the module cannot be selected in the menu, this indicates that the module
license is not contained in that oscilloscope. Install the module in an oscilloscope
that does contain the module license and then perform step 4.
5. The module is returned to the default state.
MDO4000 Series Oscilloscopes and Application Modules Decla ssification and Security Instructions 5
To Next Page
Loading...
Need help?
General
