2. Put fingers in handle hub holes on both side of the grill and pull the grill from the rear case.
3. Use a screwdriver with T
-10 Torx tip to remove the six screws securing the rear case to the rear chassis.
4. Slide away the rear case from the rear chassis.
5. To reinstall, reverse the above steps. Tighten the six T-10 Torx rear case screws to 0.65 N·m.
Removal of the rear chassis assembly
The following procedure describes the removal and replacement of the rear chassis assembly.
Prerequisite:
Maintenance
4 Series MSO (MSO44, MSO46) Service 21
To Next Page
Loading...
Need help?
General
