Maintenance
This section contains information needed to perform periodic maintenance on the instrument.
CAUTION: Do not remove the top cover from the instrument except to replace a damaged cover. There are no user replaceable
parts inside the instrument. Return the instrument to Tektronix if it requires service.
Cleaning
Use a dry, soft cotton cloth to clean the outside of the unit. If any dirt remains, use a cloth or swab dipped in a 7 % isopropyl alcohol
solution. Use a swab to clean narrow spaces around controls and connectors. Do not use any liquid cleaning agents or chemicals that
could damage the case, controls, markings or labels, or possibly infiltrate the case.
Performance verification interval and adjustment
The voltage and timing references inside the instrument are very stable over time and do not need routine adjustment.
If periodic calibration is one of your organization's requirements, a general rule is to verify performance every 2000 hours of operation
or once a year if the instrument is used infrequently. Use the procedures in the instrument Specifications and Performance Verification
manual, available online at www.www.tek.com/product-support.
If the instrument fails the performance tests in the Specifications and Performance Verification manual, adjustment may be required.
Adjustment can only be performed by a Tektronix Service Center. See Contacting Tektronix, following the title page in this manual, for
information on contacting Tektronix Service Support.
Replaceable parts list
This section contains replaceable parts information for your instrument. Use the lists in the appropriate section to identify and order
replacement parts for your product.
Standard accessories
Standard accessories for these products are listed near the beginning of this manual.
Replaceable parts
The following figure shows the user-replaceable parts for the instrument. There are no user-replaceable parts inside the instrument.
Maintenance
MSO58LP 5 Series MSO Low Profile Quick Start Manual 63