Rackmounting the Instrument (SP G600 Only)
SPG600 & SPG300 Sync Pulse G enerators Quick Reference Manual
31
1. Working from the front of the rack, pull the inner track of each slide-out
track assembly until it extends out the front of the rack. Continue to pull
them out until they lock.
2. Insert the instrument left and right tracks into the ends of the rack tracks just
extended. Make sure to insert the instrument tracks inside of the inner rack
tracksextendedinstep1.
3. Push the instrument into the rack until it stops.
4. Push both stop latches, located on the outside of each track, and continue to
slide the instrument all the way into the rack.
5. Tighten the two screws that were left loose at the rear of the rack when you
didstep3inMounting the Slide-out Tracks on page 30, and then pull the
instrument part way out of the rack.
6. Be sure the two screws that were left loose at the front of the rack are loose
enough to allow the slide-out track assemblies to seek the appropriate
positions.
7. Retighten the two screws and push the instrument all the way into the rack.
If the tracks do not slide smoothly, readjust the rail assemblies using the
method just detailed.
8. When adjusting is completed, tighten all rail assembly 10-32 screws using
28 inch-lbs of torque.
9. Using a number two Phillips screwdriver, install the 10-32 screw attached to
your rack in one of the two mounting holes at the right side of the front
panel. Repeat for the second mounting hole. Tighten both screws using
25 inch-lbs of torque.
10. Repeat step 9 to install the two screws in the left side of the front.
Installing the Instrument
To Next Page
Loading...
Need help?
General
