Maintenance
Front-Panel Module
You will need a t
orque-limiting Torx T-15 screwdriver and a flat-blade screwdriver
for this procedure.
Refer to the ex
ploded view diagram for the 2-channel models or the 4-channel
models. (See page 8-4.) (See page 8-6.)
Removal.
1. Remove the power button and rear case. (See page 8-10.)
2. Remove the
internal assembly from the front case. (See page 6-13, Internal
Assembly.)
3. Disconne
ct the front-panel cable from J1 on the Front-Panel module.
4. Remove the five screws attaching the Front-Panel module to the internal
assembl
y.
5. Pull the module away from the internal assembly.
Installation.
1. Connect the front-panel cable to J1 on the Front-Panel module by pushing the
cable
straight down into the connector.
2. Install the five screws to attach the Front-Panel module to the internal
asse
mbly.
3. Assemble the oscilloscope by performing the installation procedure for each
mod
ule that was removed.
TDS2000C Series Oscilloscope Service Manual 6–21
To Next Page
Loading...
Need help?
General
