effect on the stove’s efficiency that the insulation cracks. However, it should be
changed when the wear surpasses half of the original thickness.
Painting the stove with Senotherm-spray can cover spots or small scratches
from kettles and such. Larger damages needs to be ground with fine steel
wool, vacuumed and then sprayed. The can has to be shaken vigorously and
then sprayed on at a distance of 15-20 cm. It is very important that the stove
is not in use and completely cold before you use the spray due to the fire
hazard. In order to keep the stove’s varnished surfaces looking nice for years
to come you should try to avoid touching the varnished surfaces when the
stove is hot. Make sure to have sufficient ventilation when using spray paint.
Glass normally does not need any maintenance apart from cleaning. This is
most easily done by using TermaTech’s glass cleaner. Remember only to use
glass cleaner when the stove is cold.
Original parts which need to be changed due to wear can be found at your
dealer. Because of fit etc. only original parts from TermaTech should be used.
Flue / Chimney must be swept on regular occasions, as per manufacturers
recommendations.
Right to claim compensation for defective product is under current law.
When stating deviations the use of the product must be suspended
immediately and the dealer must be contacted.
4. HINTS
Lighting after long break
If the stove has not been used for a long time the chimney should be checked
for possible blockage before lighting. Furthermore it is a good idea to remove
any dust from the wood-burning stove as it might smell after a long break.
Chimney fire
In case of chimney fire the doors, drawers and damper of the wood-burning
stove must be closed immediately in order to shut of the supply of oxygen. The
relevant authorities must be notified if necessary. The stove must not be used
until the chimney has been inspected.
Kindling is the designation for finely split wood/sticks that are about 20 cm
long and have a diameter of 2-3 cm.