31
The stove is dicult to light and may die out
There may be a number of causes. The most typical are:
• The damper is not suciently open.
• The rewood is too wet.
• The draught in the chimney is too small or maybe it is blocked or leaking.
• The ember layer was too small/incinerated and did not give enough heat to light the logs.
Possibly give some start-up air to the re by opening the damper (pushed down and to the
right) to get the stove going again. Then the damper has to be closed again (back to position
between left and the middle).
Depending on the problem it may be necessary to contact the dealer, installer or a chimney
sweep.
The glass soots up
The wood is too moist.
Lack of draught in the chimney.
Check that the damper is not closed.
Door is closed too early at lighting (point 3 section 2).
TECHNICAL SPECIFICATIONS
TT20 TT20R TT20Streaml. TT20Streaml. R
Nominal heat output: 5 kW 5 kW 5 kW 5 kW
Height: 1045mm 1045mm 954mm 956mm
Width: 478mm 531mm 478mm 531mm
Depth: 419mm 419mm 419mm 419mm
Weight ca.: 117kg 118kg 102kg 110kg
TT20S+SA TT20RS TT21R TT21RS
Nominal heat output: 5 kW 5 kW 5 kW 5 kW
Height: 1075mm 1075mm 1073mm 1075mm
Width: 470mm 531mm 519mm 531mm
Depth: 419mm 419mm 412mm 419mm
Weight ca.: 155/140kg 174kg 120kg 174kg
TT21RL TT21RLS TT21RH TT21RHS
Nominal heat output: 5 kW 5 kW 5 kW 5 kW
Height: 993mm 995mm 1170mm 1172mm
Width: 519mm 531mm 519mm 531mm
Depth: 412mm 419mm 412mm 419mm
Weight ca.: 119kg 170kg 129kg 185kg
Average values for testing of TT20/21 models:
Exhaust gas temperature 273 °C
Exhaust gas mass ow 4.0 g/s
Eciency 83,4%
Nominal Heat output 5 kW
Flue draught 12 Pa
To Next Page
Loading...
Need help?
General
