3 INS352-5
3. Mounting the Unit
WALL MOUNTING
For wall mounting, the
cable should be brought
through the wall into the
cable entry hole.
Cable Entry
Cable Entry
Conduit Entry
Cable
Channels
SURFACE WIRING
For surface wiring, use the appropriate knockout in the
top or bottom of the unit. If wiring from the top, use the
knockouts in the top cap and run the cable down the
cable channels and into the unit as shown.
REAR TAMPER
To enable the rear tamper, the breakaway keyhole
section must be securely fixed to the mounting surface.
Front View
Rear View
Cable Entry
Knockout in Top Cap
To Next Page
Loading...
Need help?
General
