EasyManuals Logo
Home>Thermo>Chiller>NESLAB RTE Series

Thermo NESLAB RTE Series User Manual

Thermo NESLAB RTE Series
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
- 29 -
Nitrogen Purge
(Digital One/Digital Plus)
Units are equipped with nitrogen purge line designed to accept a constant flow
of dry nitrogen into the reservoir. The nitrogen blankets the cooling fluid reduc-
ing fluid evaporation.
Connect your nitrogen line to the N2
1
/8" OD tube on the rear of the unit.
Accessories
(Digital One/Digital Plus)
Autorefill Accessory
The autorefill accessory attaches to the rear of the bath. The autorefill provides
makeup water to replace bath fluid lost to evaporation, etc. It will require a tap
water source. A reservoir level float switch and logic/signal are already installed
in the bath.
When tap water is available, the bath is turned on, and the fluid reaches the
lower 1 inch horizontal level indicator located in the reservoir the autorefill
begins filling the bath. The autorefill shuts off when the fluid reaches the upper
indicator, or if the bath is turned off.
Description Part Number
100-115V/50/60Hz 611012000001
200-240V/50/60Hz, No line cord 611028000001
Cap Tube
Tap Water Inlet
Power Supply Inlet
Autorefill Control
Cable Attachment
Autorefill Module
Installation and Operation
NOTE: Power the Autorefill Accessory with an AC Adapter that is UL Listed
with the following ratings:
- Class 2
- Input rated 100-240 VAC, 47-63 Hz, 0.4A
- Output rated 12VDC, 1.25A Max.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Thermo NESLAB RTE Series and is the answer not in the manual?

Thermo NESLAB RTE Series Specifications

General IconGeneral
BrandThermo
ModelNESLAB RTE Series
CategoryChiller
LanguageEnglish

Related product manuals