Setting Clock Time and Alarm Time
Setting Clock Time
Rotate the Clock-Set Thumbwheel control to set the clock
to the current time.
Setting Alarm Time
Rotate the Alarm-Set Thumbwheel control to position the
Alarm Hand to the desired alarm time.
Note: This is an analog clock, with a 12-hour display. The time
and alarm can not distinguish between AM and PM
times, so if the Mode Switch is activated the alarm
will sound during both AM and PM times.
Operating the Alarm and Snooze Features
1. Set the alarm time as indicated above in Setting Alarm Time.
2. To wake to the radio, set the Mode Switch to the AUTO
position. When the alarm sounds, the radio will play the station
the clock is set to (see Listening to Radio). The radio will only
play when the AC Power Cord is plugged in.
3. To wake up to the buzzer, set the Mode Switch to the
ALARM position. When the buzzer alarm sounds, the clock
backlight will also flash.
4. When the alarm sounds, you may turn off the alarm or activate
the Snooze feature. To turn off the alarm, set the Mode
Switch to Off.
Note: When the alarm sounds, it will play for a maximum of 40
minutes or until manually stopped before turning off
automatically. This cycle will repeat every 12 hours until
the alarm is deactivated.
5. To use the snooze feature, press the Snooze/Backlight
Button. The alarm will turn off for approximately nine minutes
before sounding again. You may repeat this process several
times during the 40-minute snooze cycle.
To Next Page
Loading...
Need help?
General
