11
ENG
RESISTANCE ADJUSTMENT
The preferred level of diculty in pedalling (resistance) can be regulated in ne increments
by use of the resistance knob. To increase the resistance, turn the resistance knob
clockwise. To decrease the resistance, turn the knob counter clockwise.
IMPORTANT: To stop the ywheel (wheel) while pedalling, push down on the red brake
knob. The ywheel should quickly come to a complete stop. Please make sure your shoes
are xed into the toe clip. Please apply full resistance load when bike is not in
use to prevent from injuries due to moving drive gear components.
HOW TO MOVE THE INDOOR CYCLE:
Due to the weight of the TOMAHAWK IC1 Indoor Cycle, it is recommended that two persons
move it. While one person lifts the back of the indoor cycle, the second person rmly holds the
handlebar and tips the indoor cycle forward until it rolls on the wheels. Carefully move the In-
door Cycle to the desired location and then lower it. CAUTION: To reduce the risk of injury, use
extreme caution while moving the TOMAHAWK IC1 Indoor Cycle. Do not attempt to move it
over uneven surfaces and make sure there’s a safety space of 20 inch (minimum) to the nearest
equipment is (recommended).
If the indoor cycle rocks on the oor after
being set down, turn the leveling feet
underneath the front or rear stabilizer
until the rocking motion is eliminated.
Important: Please do not unscrew the
leveling feet more then 1⁄2 inch.
RED RESISTANCE KNOB
EMERGENCY BRAKE
LEVELING FEET
FLYWHEEL LOCK
HOW TO OPERATE THE
INDOOR CYCLE
WARNING! The TOMAHAWK IC1 Indoor Cycle has a direct driven ywheel (wheel); the pedals will continue to move
together with the ywheel until the ywheel stops. Reducing speed in a controlled manner is required. To stop the
ywheel immediately, push down the red emergency break knob. Always pedal in a controlled manner and adjust
your desired cadence according to your own abilities.
PUSH THE RED KNOB DOWN = EMERGENCY STOP
To Next Page
Loading...
Need help?
General
