Connect your navigation device to your LINK 530 to fully enjoy the benefits of your WORKsmart
solution.
To use a TomTom PRO navigation device in combination with the LINK 530 a corresponding
WEBFLEET subscription is required.
When you first switch on your navigation device, you are asked to connect it with the LINK 530
installed in your vehicle. You can do this immediately or at any time later by doing the following:
1. Make sure that the LINK 530 is connected to power and has a mobile network connection.
2. Switch on your navigation device.
3. Tap the screen to bring up the Main Menu.
4. Tap WORK.
You are asked to start the activation process. After you have started the activation process
your navigation device starts searching for Bluetooth devices.
If your navigation device finds more than one Bluetooth device, it shows a list of the available
devices. Continue with step 5.
If your navigation device finds only one LINK 530, continue with step 6.
5. Select your LINK 530 from the list.
The name starts with LINK followed by the serial number of your LINK 530 or the licence plate
number of your vehicle. You can find the serial number on the outside of your LINK 530.
6. Enter the Activation Code, which you can find in your WEBFLEET contract confirmation.
Select the appropriate subscription from the list, if there are several subscriptions to choose
from. Enter a name for your LINK 530 if you are asked to do so.
7. Enter the licence plate number of the vehicle.
8. Select the appropriate vehicle type.
To Next Page
Loading...
Need help?
General
