Chapter 6
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Note: Download a free copy of the electrical or hydraulic schematic by visiting www.Toro.com and
searching for your machine from the Manuals link on the home page.
IMPORTANT
Refer to your engine owner’s manual and cutting unit Operator's Manual for
additional maintenance procedures.
Recommended Maintenance Schedule
Maintenance
Service Interval
Maintenance Procedure Part No.
Qty Description
After the first 8
hours
Torque the wheel nuts.
- - -
After the first 50
hours
Change the front planetary-gear
oil.
- - -
After the first 200
hours
Change the oil in the rear axle.
- - -
Before each use or
daily
Inspect the seat belt(s).
- - -
Check the interlock switches. - - -
Check the air filter.
108-3814 1 Outer air filter
108-3816 1 Inner air filter
Check the engine-oil level, add
engine oil as needed.
121-6393 1
10W-30 Premium Engine Oil (5
gallons)
121-6392 1
10W-30 Premium Engine Oil (55
gallons)
121-6395 1
15W-40 Premium Engine Oil (5
gallons)
121-6394 1
15W-40 Premium Engine Oil (55
gallons)
Drain the water separator.
- - -
Check the tire pressure.
- - -
Visually inspect the rear axle for
leaks.
- - -
3466-702 A Page 6–1 Maintenance
To Next Page
Loading...
Need help?
General
