9
Air Cleaner Service
1. Press the upper latch tabs and rotate the top of the cover outward to open and remove the cover.
2. Remove the paper air filter and the foam pre-filter.
3. Inspect the foam pre-filter, and replace it if damaged or excessively dirty.
4. Inspect the paper air filter.
NOTE: If the paper air filter is excessively dirty, damaged or is wet with oil or fuel, replace it.
5. Remove dirt from the air cleaner body and cover using a moist rag. Do not wipe dirt into the air duct.
6. If the foam pre-filter is reusable, clean it with warm soapy water. Thoroughly rinse and dry foam element.
7. Insert the foam pre-filter and the paper air filter into the air cleaner
8. Properly Install the cover and verify cover latch tabs are fully engaged.
To Next Page
Need help?
General
