7. R elease the blade control bar .
8. Immediately push the mo w er o v er the newspaper ball.
9. Stop the engine and w ait for all mo ving par ts to stop .
10. Go to the front of the mo w er and c hec k the newspaper
ball.
Note: If the newspaper ball did not g o under the
mo w er , re peat ste ps 4 through 10 .
11. If the newspaper is unra v elled or shredded, the blade
did not stop properly , whic h could result in an unsafe
operating condition. Contact an A uthorized Ser vice
Dealer .
Recycling the Clippings
Y our mo w er comes from the factor y ready to recycle the
g rass and leaf clippings bac k into the la wn.
If the g rass bag is on the mo w er , remo v e it (refer to
R emo ving the Grass Bag) before recycling the clippings . If
the side disc harg e c hute is on the mo w er , remo v e it and
loc k the side disc harg e door (refer to R emo ving the Side
Disc harg e Chute) before recycling the clippings .
Important: Ensur e that the r ear discharge plug is in
place bef or e y ou r ecy cle the clippings ( Figur e 34 ).
Figure 34
Bagging the Clippings
Use the g rass bag when y ou w ant to collect g rass and leaf
clippings from the la wn.
A w or n g rass ba g could allo w small stones and
other similar de bris to be thr o wn in the operator’ s or
bystander’ s dir ection and r esult in serious per sonal
injur y or death to the operator or bystander s.
Check the g rass ba g fr equentl y . If it is dama ged,
install a new T or o r eplacement ba g .
If the side disc harg e c hute is on the mo w er , remo v e it and
loc k the side disc harg e door (refer to R emo ving the Side
Disc harg e Chute) before bag ging the clippings .
T he blade is shar p; contacting the blade can r esult
in serious per sonal injur y .
Stop the engine and w ait f or all mo ving par ts to stop
bef or e lea ving the operating position.
Installing the Grass Bag
1. Raise and hold up the rear door ( Figure 35 ).
13