5. R emo v e the wire from the spark plug and connect the
wire onto the retaining post.
6. R emo v e the spark plug, add 1 oz. (30 ml) of oil through
the spark plug hole , and pull the star ter rope slo wly
sev eral times to distribute oil throughout the cylinder to
prev ent cylinder cor rosion during the off-season.
7. Loosely install the spark plug .
8. Tighten all n uts , bolts , and screws .
9. Charg e the batter y for 24 hours , then unplug the batter y
c harg er and store the mo w er in an unheated area. If y ou
m ust store the mo w er in a heated area, y ou m ust c harg e
the batter y ev er y 90 da ys (model 20058 only).
Folding the Handle
If, while f olding the handle f or storing or transpor ting
the mo w er , y ou accidentl y bump the k ey and enga ge
the blade contr ol bar , the engine could star t and
r otate the blade, causing serious per sonal injur y .
Al w ays r emo v e the ignition k ey bef or e y ou f old the
handle.
1. R emo v e the lo w er handle knobs ( Figure 55 ).
Figure 55
Note: Attac h the lo w er handle knobs onto the bolts in
the handle to prev ent losing them.
2. Detac h the lo w er handle brac k ets from the lo w er end of
both handle sides ( Figure 55 ).
3. R otate the handle forw ard ( Figure 56 ).
Important: R oute the ca bles to the outside of the
handle knobs as y ou f old the upper handle.
Figure 56
4. T o unfold the handle , refer to Unfolding the Handle .
Removing the Mower from
Storage
1. R emo v e the spark plug and spin the engine rapidly using
the star ter to blo w the ex cess oil from the cylinder .
2. Install the spark plug and tighten it with a tor que
wrenc h to 15 ft-lb (20 N ⋅ m).
3. Charg e the batter y (model 20058 only).
4. Connect the wire to the spark plug .
20
To Next Page
Loading...
Need help?
General
