17
Mixing the Fuel
DANGER:
Gasoline is extremely ammable and explosive.
A re or explosion from gasoline will burn you
and others.
This product is powered by a 2-cycle engine and requires
pre-mixing gasoline and 2-cycle oil. The oil mix should be
50:1, using oil that meets or exceeds JASO-FC specica-
tions.
Follow these steps to mix the fuel.
1. Obtain a clean container that is approved for use with
gasoline.
2. Mix the 2-cycle engine oil provided with unleaded
gasoline in the container, according to the instructions
on the oil carton.
Important: This engine is certied to operate on unleaded
gasoline intended for automotive use with an octane rating
of 87 ([R + M] / 2) or higher. Do not use automotive oil or
2-cycle outboard oil. Store the container out of the reach of
children.
50:1 Gasoline to Oil Mixing Chart
Gasoline Oil
1/2 US gallon 1.3 oz.
1 US gallon 2.6 oz.
2 US gallons 5.2 oz.
1 liter 20 ml
2 liters 40 ml
3 liters 60 ml
4 liters 80 ml
5 liters 100 ml
+ =
Operation
Filling the Tank
WARNING:
Always stop the engine before lling the tank.
Never add fuel to a machine with a running or
hot engine. Move at least 30 ft. (9 m) away from
the refueling site before starting the engine. Do
not smoke while lling the tank.
Follow these steps to ll the tank.
1. Clean the surface around the fuel cap to prevent con-
tamination.
2. Loosen the fuel cap by turning it counterclockwise.
3. Pour the fuel mixture carefully into the tank.
4. Clean and inspect the gasket.
Note: Replace the fuel cap if the gasket is damaged.
5. Install the fuel cap and tighten it by turning it clock-
wise.
WARNING:
Check for fuel leaks. If you nd any leaks, correct
the problem before using the product.
6. Wipe spilled fuel from the product.
7. Move at least 30 ft. (9 m) away before starting the
product.
Note: It is normal for the engine to emit smoke during
use.
Operation
To Next Page
Need help?
General
