Toro 51950 User Manual

18
19
WARNING:
The product may throw objects during opera-
tion, causing injury to the operator or to by-
standers. Always wear suitable eye protection,
long heavy pants, and boots while operating the
product.
Starting the Product
See Figure 14a, Figure 14b, and Figure 15.
Starting the product differs depending on whether the engine
is cold or warm. Refer to the label on the air lter cover.
To Start a Cold Engine
Follow these steps to start a cold engine.
1. Lay the product on a at, bare surface.
2. Toggle the switch to the I (ON) position.
3. Push the primer bulb approximately eight times.
4. Set the choke lever to A (Choke Closed).
5. Press the lock-off button and squeeze the trigger.
6. Pull the starter cord three times.
7. Set the choke lever to B (Choke Open).
8. Press the lock-off button and squeeze the trigger.
9. Pull the starter cord.
Note: If the product starts, let it run for 30 seconds
before using it. If the product does not start, repeat the
previous steps.
Figure 14b
To Start a Warm Engine
Follow these steps to start a warm engine.
1. Lay the product on a at, bare surface.
2. Toggle the switch to the I (ON) position.
3. Push the primer bulb up to eight times.
4. Set the choke lever to B (Choke Open).
5. Do not squeeze the trigger.
6. Pull the starter cord.
Note: If the product does not start, repeat the previous
steps.
Stopping the Product
See Figure 15.
Follow these steps to stop the product.
Release the trigger.
Toggle the switch to the O (OFF) position.
Figure 15
Operation
Figure 14a
Lock-off
Button
Switch
Starter
Cord
Trigger
Primer
Bulb
Trigger
Switch
Set Choke to A
Set Choke to B

Toro 51950 Specifications

General

Brand	Toro
Model	51950
Category	Trimmer
Language	English