EasyManuals Logo
Home>Toro>Snow Blower>CCR POWERLITE 38182

Toro CCR POWERLITE 38182 User Manual

Toro CCR POWERLITE 38182
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
4. Shak e the container to mix the g asoline and oil
thoroughly .
5. Slo wly remo v e the cap and add the remaining amount
of g asoline .
Note: Do not mix g asoline and oil in the fuel tank. Oil
at room temperature mix es easier and more thoroughly
than cold oil. Oil belo w 32°F (0°C) requires additional
mixing .
Filling the Fuel Tank
Fill the fuel tank with a fresh mixture of g asoline and oil
mix ed at the proper ratio ( Figure 8 ).
Figure 8
Starting the Engine
1. T ur n the ignition k ey cloc kwise to the On position.
2. Mo v e the c hok e lev er to the right.
3. Fir mly push in the primer 2 times with y our thumb ,
holding the primer in for a second before releasing it
eac h time .
4. Star t the engine b y using either the electric star t button
or the recoil star ter .
Using the r ecoil star ter : Hold the sno wthro w er
handle with one hand and pull the recoil star ter
vig orously with the other hand.
Using the electric star ter :
A. Connect the po w er cord to the sno wthro w er and to
a standard household po w er outlet and push the
star ter button.
Important: R un the electric star ter no mor e
than 10 times at inter v als of 5 seconds on, then
5 seconds of f. R unning the electric star ter
extensi v el y can o v erheat and dama ge it. If
the engine does not star t after this series of
attempts, w ait at least 40 min utes to allo w the
star ter to cool bef or e attempting to star t it
a gain. If the engine does not star t after the
second series of attempts, tak e the sno wthr o w er
to an Authoriz ed Ser vice Dealer f or ser vice.
B . W hen the engine star ts , disconnect the po w er cord
from the sno wthro w er and the outlet.
5. With the engine r unning, mo v e the c hok e lev er to the
left slo wly .
Stopping the Engine
T o stop the engine , tur n the ignition k ey countercloc kwise
to the Off position.
Adjusting the Discharge Chute
T o adjust the disc harg e c hute , mo v e the c hute handle and
the c hute deflector handle as sho wn ( Figure 9 ).
Figure 9
1. Chute handle 2. Chute deector handle
Preventing Freeze-up after Use
Let the engine r un for a few min utes to prev ent mo ving
par ts from freezing . Stop the engine , w ait for all
mo ving par ts to stop , and remo v e ice and sno w from
the sno wthro w er .
With the engine off , pull the recoil star ter handle
sev eral times and push the electric star t button once
(if applicable) to prev ent the recoil and electric star ters
from freezing up .
7

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toro CCR POWERLITE 38182 and is the answer not in the manual?

Toro CCR POWERLITE 38182 Specifications

General IconGeneral
BrandToro
ModelCCR POWERLITE 38182
CategorySnow Blower
LanguageEnglish

Related product manuals