Dial position: % SCALING (Seasonal adjust)
In this dial position you can increase or decrease the RUN TIME of all
stations in that program by percentage scaling from 0% to 200% in 10%
increments.
Press PROG to select the program you wish to scale.
Press +/ON or -/OFF to change.
The Initial RUN TIME represents 100%. The controller will record the change, i.e.,
if a program was scaled down to 80%, next time you enter this dial position the
display will show 80%.
To set a program to "OFF"
If you wish to stop irrigation of a program, set percentage scaling to 0%.
The display will show that program is OFF.
To resume normal operation of that program, Dial to "% SCALING" and increase
the percentage to your desired value. Increasing to 100% will set RUN TIME to its
original value.
Press PROG to select the program.
Press DIAL to advance to MANUAL.
Dial position: MANUAL
The MANUAL mode allows immediate customized irrigation on one or more
zones. You can set an individual RUN TIME for each of the stations you wish to
start manually. The controller has a "programmable manual" function, so if you
manually operate more than one station, they will open in sequence.
Press +/ON or -/OFF to set the station RUN TIME.
Press NEXT to advance to next station.
To turn ON the 1st station in the sequence:
Press DIAL to AUTO-RUN position.
Press -/OFF (in AUTO-RUN position) to turn OFF the sequence.
All stations with a manually programmed RUN TIME will be displayed. Operating
stations will flash and the display will show the remaining RUN TIME of the station
(count down).
Press DIAL to advance to SEMI-AUTO.
-8-
% SCALING
MANUAL
To Next Page
Loading...
Need help?
General
