Note: The ECx timer is not weather resistant and
must be installed indoors or in a protected area.
For
outdoor installation, an optional weather-resistant out-
door cabinet (model # 53335) is available.
1. Select a location for the timer within 4' (1.2m) of an
electrical outlet to enable the transformer wires to
easily reach. Make sure the outlet is not controlled by
a light switch.
2. Remove the mounting bracket attached to the back
of the timer housing by pulling the lower edge of the
bracket away and downward from the timer housing.
3. Place the mounting bracket (A) against the wall align-
ing the top edge at about eye level. Drive three 1"
(25mm) wood screws (B) into the wall through the
three holes provided in the bracket.
Note: If you are installing the bracket on drywall or
masonry, install screw anchors (C) to prevent screws
from loosening.
4. Align the slotted openings on the back of timer hous-
ing with the mounting bracket tabs. Slide the timer
downward to engage the tabs.
Note: Store the Quick Reference Guide and the
Watering Schedule Form in the pocket (D) between
the timer and bracket.
Mounting The Timer
Installation
22
To Next Page
Loading...
Need help?
General
