EasyManuals Logo
Home>Toro>Lawn Mower>Groundsmaster 4700-D

Toro Groundsmaster 4700-D Service Manual

Toro Groundsmaster 4700-D
347 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #218 background imageLoading...
Page #218 background image
Groundsmaster 4500 --D/4700--DPage 5 -- 26Electrical System
Traction Pedal Position Sensor Calibration
IMPORTANT: A properly installed and calibrated
traction pedal position sensor is critical to accurate
traction system response and for reliable sensor
life. Use care when removing, installing and cali-
brating the traction pedal position sensor.
Calibration of the traction pedal position sensor ensures
that the TEC controller can identify the traction neutral,
forward and reverse positions.
1. Park machine on a level surface, lower cutting
decks, engage parking brake and stop engine.
2. Turn ignition switch to RUN but do not start engine.
3. Use the InfoCenter Display Settings menu (see Info-
Center Display in this chapter) to obtain and select Pro-
tected Menus. Enter valid PIN for the m achine to allow
access to protected menu items including calibration of
the traction pedal position sensor. The InfoCenter dis-
play screen should indicate PIN in the upper right hand
corner when the correct PIN number has been entered.
4. Use the InfoCenter Display Service menu (see Info-
Center Display in this chapter) to obtain and select the
Traction Pedal menu item. The InfoCenter display
should indicate that the traction pedal calibration pro-
cess is engaged (Fig. 23).
5. Follow the prompts on the InfoCenter display screen
to calibrate the traction pedal position sensor. The calib-
ration steps are listed below:
A. Slowly press traction pedal to the forward direc-
tion.
B. Press and hold traction pedal to the full forward
position.
C. Allow traction pedal to return to the neutral posi-
tion.
D. Slowly press traction pedal to the reverse direc-
tion.
E. Press and hold traction pedal to the full reverse
position.
F. Check that InfoCenter display indicates a suc-
cessful calibration process (Fig. 24).
6. Turn ignition switch to OFF which exits the traction
pedal calibration menu.
1. Traction pedal 2. Pedal position sensor
Figure 22
1
2
Figure 23
ADVISORY #172
Calibrate Teach Is
Engaged
Figure 24
ADVISORY #172
Calibrate. Exit Good

Table of Contents

Other manuals for Toro Groundsmaster 4700-D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toro Groundsmaster 4700-D and is the answer not in the manual?

Toro Groundsmaster 4700-D Specifications

General IconGeneral
BrandToro
ModelGroundsmaster 4700-D
CategoryLawn Mower
LanguageEnglish

Related product manuals